Low Voltage Light Manufacturers introduced that solar street lights are highly energy-efficient, but the choice of accessories is very important, especially the choice of lighting sources. The light source is not the most expensive part in the configuration of solar street lights and solar garden lights, but it is the most critical part. In terms of failure rate, the failure rate of the light source is the highest among all solar street light components, so the selection, design and installation of the light source are very important.

Considering price, life, reliability, luminous efficiency, power range, uniformity and color temperature, the village lights still use DC energy-saving lamps and induction lamps as the way, while street lamps are suitable for metal halide lamps, induction lamps and high-pressure sodium lamps. In order to solve the problem of failure rate of DC energy-saving lamps, split-type lamps can also be considered, and the DC electronic ballast and lamp tube are installed separately to facilitate heat dissipation.

For the new light source, high-brightness LED, as a landscape light and display light source, it has shown good energy-saving effect and high reliability, but as a solar street light for lighting purposes, if it is to achieve the same lighting effect as other high light efficiency light sources Because of its lack of advantages in light efficiency, LEDs cannot save energy. For some lighting occasions that can be accepted as long as the "light under the lamp" is acceptable, LED light sources with lower power than other light sources can be used to achieve the effect of energy saving. The biggest advantage of the LED light source at present is its long life. Under the condition of taking certain measures, such as adding a reflector and appropriately adjusting the illumination angle of the LED light bar, it is also necessary to make up for the shortcomings of the LED itself. To achieve a better lighting effect, but to truly achieve high reliability and long life of the LED light source, the heat dissipation and constant current drive of the lamp must pass the test.

Through the above introduction, Solar Motion Sensor Light Manufacturers hopes that you can simply refer to the content of this article in future use.