The one-of-a-kind Clamp Making Tool allows you to make strong, reliable clamps out of simple Stainless Steel Safety Wire. It can be used to replace worn or ineffective hose clamps, or to create clamps on virtually any material by tightening wires around an object and locking them in place. Follow these instructions given by saddle clamp manufacturer to create your own clamps today!

Single Wrap Application
Step 1
Insert end of wire into front pin on the left side of the tool
Bring wire over the nose and in front of the front pin on the right side of the tool
Wrap wire around hose or object to clamp (as many wraps as desired)
Bring wire over the top of the wraps and around the rear pin on the right hand side
Take wire over the top of the tool and around the pin on the left hand side

Step 1 (Alternative)
Place loop of wire around nose and twist to tighten
Wrap wire around hose or object to clamp (as many wraps as desired)
Bring wire over the top of the wraps and around the rear pin on the right hand side
Take wire over the top of the tool and around the pin on the left hand side

Step 2
Turn wing nut to tighten
When clamp has reached desired tension, rotate tool 180° to lock clamp
Loosen wing nut and remove clamp making tool
Clip wire ends about ¼ inch from clam and push down toward hose or object clamped

Double Wrap Application

Step 1
Cut wire to length (4 times around project plus 12” for tool)
Fold wire in half, tape or wire nut ends together
Wrap around hose where you want a clamp
Tuck ends through the loop

Step 2
Continue to wrap around in the same direction; tuck through loop again and remove tape or wire nut
Place tool as shown with wire over front pin and around rear pin
Twist ends together tightly about 6 twists as close to the body of the tool as possible

Step 3
Place notch at end of tool against the wire loop
Turn wing nut clockwise to tighten (right hand threads)

Step 4
Rotate tool over to lock the clamp, bending wires back over themselves
Loosen wing nut and remove the tool
Clip off wire ends about ¼ inch from clamp and push ends down against the hose.

As you can see, the Clamp Making Tool allows you to create strong and versatile clamps anytime, anywhere, on any material. Never be caught without the right size clamp again when you have the Clamp Making Tool and Stainless Steel Safety Wire on hand!

quick fitting is also one of our products, welcome to buy and purchase!