How to use Manual Seeder:
Lower grain adjustment: The next grain inserts the board on top of two grains, the next two sowing inserts on one grain, and the next three grains unplug the board. Note: When adjusting the board, the seed box must be adjusted without seeds. The planting depth can be adjusted up and down according to the soil moisture of the plot.
Lower fertilizer adjustment: Pull out the adjustment block on the shaft and jump to the required lower fertilizer amount.
Seeding regulation: Move the clinker pressure pad under the scraping rubber skin to the direction of the seed shaft, remove the three screws, thread it through the three holes at the back, and leave a gap between the rubber skin and the shaft.
Shaft change method: without any tools, just twist the shaft head cover in the direction you want to remove the shaft head cover; when you put the shaft head cover in the right direction, twist it in the direction of back to close, screw That's it.
The use process should pay attention: the lower seed shaft is cleaned once a day, and then used after drying. Only when the shaft is smooth, can the lower seed be more accurate. If the clinker parts are damaged, you can use the two good glue bonding.
After the annual spring ploughing, after the Manual Fertilizer Seeder is cleaned with water and dried, apply rust-proof oil to all metal parts and store in a cool and dry place so that it can be used in the coming year.