The cutting quality specification and roughness of the marble cutting machine. The laser cut section will form a vertical line. The depth of the line determines the roughness of the cut surface. The shallower the line, the more lubricious the cut section. Verticality. Can the edge angle of the incision be vertical, and can the slope be too large?

  Cutting width. Generally speaking, the cutting width does not affect the cutting quality. The cutting width has an important effect only when a particularly fine contour is formed inside the component. This is because the cutting width determines the small inner warp of the contour. When the plate thickness increases, the cutting width also changes. The increase.


   Lines. When cutting thick plates at high speed, the molten metal will not appear in the cut below the vertical laser beam, but will be ejected at the rear of the laser beam. As a result, curved lines are formed on the cutting edge, and the lines closely follow the moving laser beam. In order to correct this problem, reducing the feed rate at the end of the cutting process can greatly eliminate the formation of lines.


   Dent and corrosion. Depression and corrosion have an adverse effect on the appearance of the cutting edge and affect the appearance. They are present in cutting errors that should normally be prevented. The automatic cutting machine shall check the laser head cooling water pipeline for corrosion every six months. If there is any corrosion, it shall be disposed of or changed in time.

If you are interested in bridge saw, welcome to contact us.