Toilet WPC Door Manufacturers introduces tips on wooden door maintenance:

1. The wooden door should meet the following requirements: the filling in the first door should be full, the wooden strips on the side of the door should be planed and connected firmly, and the decorative panels and window frames should be glued firmly without warping or cracking. The surface should be flat and clean, free of knots, worm eyes, cracks, rot spots and other defects, and the lines should be clear and beautiful.

2. Check the door leaf: the door leaf should be drummed, and there should be no warping and deformation. Check whether the door leaf blades are just inserted on the door frame. If the drum and the door frame drum are too big, it means that the planing and repairing of the wooden door is not in place or the door frame is not perpendicular to the ground when the wooden door is installed. Case. This requires that the door leaf be re-planed. If the wooden door frame is not vertical, a layer of gasket should be laid in the wooden door frame and straightened.

3. Check the combination of wooden doors: for accuracy, please fix the page number. If the hinges are not right, the door leaf will fit into the frame and the wooden door will not go smoothly. At this time, it is necessary to tighten a nail on each hinge first, then adjust the degree of agreement between the wooden door leaf and the door frame, and tighten all the screws after adjustment and repair. In addition, the direction of opening the door must also comply with the rules.

4. Check the door lock: opening, closing, and locking are all proceeding smoothly, and the two parts of the door leaf and the door frame are locked. Improper installation of the door lock will cause the door lock switch to be inflexible. Open the door lock in a correct and standardized manner. The size of the door lock must be the same as the lock body and lock plate. The door lock must be installed firmly and there should be no abnormal noise when unlocking. In addition, the door lock accessories must be installed, and the fixing screws must be full and flat. Door stoppers, door closers, handles, etc. must be installed in designated locations and installed firmly.

5. The door suite should be equipped with base materials: After the door cover wood is framed, it is planed and straightened, then assembled on the wall, and then covered with the base board and decorative board. When hand knocking on the side panel, if there is a hollow drum, it means that the bottom panel is a base board such as a blockboard without a bottom panel, which should be removed and redone.