WPC flush door manufacturer introduces the installation knowledge of WPC Door:

1. Installation steps:

(1) First, draw a vertical line on the door opening.

(2) Fix the appropriate lining plate to the door opening as required.

(3) Fix the vertical sleeve on one side of the hinge, and measure the verticality of the upper and lower sides when fixing.

(4) Place the vertical sleeve and horizontal sleeve on the other side.

(5) Install the door on the vertical sleeve, and pay attention to the gap above when installing.

(6) Close the door and fix the vertical sleeve on the other side as required by the door seam.

(7) Fix the upper horizontal sleeve.

(8) Install right-angle lines inside and outside.

(9) Adhesive strips, door locks, and locking tabs.

(10) Test, check.

Through the above introduction, WPC wood door Manufacturers hopes that you can simply refer to the content of this article in future use.