To clean the surface of a whirlpool tub, start by wiping down the tub with a damp cloth or sponge to remove any dirt or grime. Next, mix a solution of mild soap and warm water and use this to scrub the tub paying extra attention to any stains or marks.

Rinse the tub thoroughly with clean water and dry with a soft, dry towel. If the tub is especially dirty or has tough stains you can try using a stronger cleaning solution such as bleach or a commercial bathtub cleaner. Turbo clean is also one of the great options in this regard.

Just be sure to follow the instructions on the label and rinse the tub well afterward. Remember to also clean the jets and other nooks and crannies of the tub regularly to prevent the buildup of dirt and bacteria.

Cleaning Frequency:

The frequency at which you should clean your tub surface will depend on how often you use the tub and the level of dirt and grime that accumulates. In general, it is a good idea to give your tub a quick turbo clean wipe down with a damp cloth or sponge after each use to remove any dirt or soap scum.

For a more thorough clean aim to deep clean your tub at least once a week or more frequently if needed. If you use your tub on a daily basis or if it gets especially dirty, you may need to clean it more often. The key is to regularly remove dirt and grime to prevent the buildup of soap scum and hard-to-clean stains following the turbo clean process.

Rinse the Tub:

Rinsing the tub is an important step in the process of turbo-cleaning the surface of your tub. After you have scrubbed the tub with soap and water and removed any stains or marks it is important to rinse away all of the soap and cleaner to avoid leaving a residue.

To rinse the tub simply turn on the tap and let the water run over the surface of the tub until it is clean and free of soap. Be sure to rinse all areas of the tub including the jets and any corners or crevices. Once you have rinsed the tub thoroughly wipe it dry with a soft, dry towel to prevent water spots.

Clean the Surface:

To clean the surface of a whirlpool tub, start by wiping down the tub with a damp cloth or sponge to remove any dirt or grime. Rinse the tub thoroughly with clean water and dry with a soft, dry towel. If the tub is especially dirty or has tough stains, you can try using a stronger cleaning solution such as bleach or a commercial bathtub cleaner. Just be sure to follow the instructions on the label and rinse the tub well afterward. Regular turbo cleaning will help to keep your tub looking clean and new.

Wipe Clean and Detailed Jets:

To wipe clean and detail the jets of a whirlpool tub, you will need a soft cloth or sponge and a mild cleaner. Begin by turning off the power to the tub and closing the drain. Then use a soft cloth to wipe down the jets removing any dirt that has accumulated.

If the jets are especially dirty you may need to use a mild cleaner or a mixture of warm water and vinegar to help loosen and remove the dirt. Once the jets are clean you can use a soft cloth or cotton swabs to detail the edges and corners of the jets removing any dirt or mud that may have stuck in these areas. Regular cleaning of the jets will help to keep your tub running smoothly and efficiently.